The spill response trailer can be deployed in any weather condition by towing to a spill site and collecting liquid from up to 75’ from trailer and 15’ below trailer deck. The diesel generator will supply lighting and power, and pumping system will recover 1000 gallons of oil/water/coolant/chemistry in 25 minutes. An oil water separator will remove floating oils for simple disposal and the single point drainage system will allow disposal of collected water through 2” drain line. Additional hose and spill response equipment is available.

The trailer includes:

• 16’ x 8’ x 8’ HD enclosed trailer with HD axles and frame
• Torflex® Rubber Torsion Axles (4” Drop)
• Electric Brakes with Breakaway Battery
• Goodyear® Radial Tires
• Silver HD Steel Wheels (E-Coated)
• Rear Door: Double
• Galvanized Steel Roof
• Clear coated aluminum fenders(powder-coated)
• .030 Prefinished Aluminum Exterior in AFB Grey
• Anodized Aluminum Roof Cove & Bottom Trim
• 1/4” Plywood Interior Sidewall Painted AFB Grey
• 3/4” Exterior Grade Plywood Floor Painted AFB Grey Epoxy
• 12 Volt End Connector (7-way plug)
• Jack Ram Hoist with Sand Pad
• 2 5 /16” Positive Lock Ball Coupler
• D.O.T. Safety Chains with Hooks
• LED Exterior Lighting
• Dual Axle Trailer with 14,000# GVW
• DOT Lighting
• LED Interior Lighting with single switch
• Blower system for inlet and outlet forced air
• Generator Access door with vented inlet air for radiator

Oily Water Storage Tank:

• Spill Response kit includes absorbents, safety glasses, face shield, HD Rubber gloves, water proof chemical resistant overalls, and 10’ spill dike.
• Tanks are set to drain easily with multi-chamber valves and clear hose for easy monitoring of draining effluent.
• Tanks are ideally suited for: oil, water, fuel, jet fuel, diesel, chemicals, wetting agents, soaps, detergent, formic acid, glycolic acid, oxalic acid, stearic acid, formaldehyde, glycols, latex, mineral oils, most alcohols, inks, ammonia solutions, acetic acid, chromic acid to 50 percent, and sulphuric acid to 95 percent.
• Maximum temperature to 150 degrees
• UV stabilized
• Translucent gray in color

Oil Water Separator Section:

• Stainless steel construction
• 475 gallon inlet settling tank
• Over 2 hours minimum dwell time promoting full settling of suspended solids
• Laminar flow with velocity reducing inlet piping
• Compound inlet settling tank promotes sheer induced settling
• 4 section tank with undercurrent design using stainless steel weir structures
• Inclined plate separator
• 15 degree walls direct solids to automatic removal system
• Submerged LED lighting with view window to monitor level
• 85 gallon coalescing tank
• 4 cu ft. of coalescing media with over 400 ft.2 of surface area
• Highly efficient polypropylene media with 100% pass through design
• Low velocity flow with vertical and horizontal flow path
• High efficiency oil skimmer with external reservoir and 1” stainless steel discharge pipe
• External stainless steel oil reservoir with handle and drain spout
• Submerged LED lighting with view window to monitor level

Extraction Pump:

• 15’ of suction with 1.5” line
• Run dry indefinitely without damage
• 20 GPM recovery rate
• Simple to field service in case of clogging
• Robust design used in marine, industrial, waste handling and spill response
• TEFC motor with gear reducing drive
• Efficiently pump up to 50% solids, designed for spill response, industrial waste, high solids waste water and harsh environments
• Supplied with 75’ of 1.5” suction line and foot valve with strainer

Power Supply:

• CARB Tier IV Particulate level (low emission diesel)
• Less than 66 dB at 20’
• Fully sound attenuated enclosure for low operational footprint
• Diesel/Kerosene/Jet Fuel operational
• Kubota 2 cylinder diesel generator with electric start 7kW 240V/120V Tier4 certified Generator
• Integrated start/stop system with built in power distribution for pumps and lights
• Single switch start
• Auto shut down for low oil, high temp, low RPM
• Insulated enclosure with radiator ducted through side wall of trailer
• Exhaust below trailer
• Integrated fuel tank for 16 hour run time
• 550# dry with enclosure, fuel tank, mounting hardware and shroud

Pressure Washer:

• 2 GPM @ 1300 PSI
• Hot water to 210°F
• Diesel heated schedule 80 steel coil with stainless steel surround
• Vented stack allows closed door operations
• 50’ HP hose with insulated dual wand
• Soap/chemical injector for spill clean-up
• Fully protected from freezing and simple to drain

Options available:

• 120V plug in for heated trailer and battery maintenance
• Exterior Flood Lights
• Spill Response kit in protective over-pack
• Filtration levels to remove contaminants to desired level
• Additional tank capacity
• Auto drain system to pump water to remote tank
• External pump wiring to allow drawing from 30’ below trailer